2000-I Wood Insert by Osburn

Proudly Made in Quebec ⚜️

Meeting the new, stricter fine particulate emission standards, the Osburn 2000 wood-burning insert stands out with its recent certification. This redesigned version delivers an impressively low particulate emissions rate of 2.3 g/h, a powerful maximum heat output of 75,000 BTU/h, and an outstanding efficiency of 79%. It retains its spacious 2.4 cu. ft. combustion chamber, along with a strategically positioned 144 CFM variable-speed fan that effectively redistributes heat throughout the room.

For seamless installation, the Osburn 2000 can be paired with an optional faceplate designed to cover masonry hearths up to 32 in. (81 cm) high and 50 in. (127 cm) wide. To match your décor, a steel door overlay is available in classic black or brushed nickel, complemented by faceplate trims.

👉 Look no further—indulge in Osburn’s legendary quality with the 2000 insert.

Appliance performance ⁽¹⁾

⁽¹⁾ Values are as measured per test method, except for the recommended heating area, firebox volume, maximum burn time and maximum heat output.

⁽⁾ Recommended heating area and maximum burn time may vary subject to location in home, chimney draft,heat loss factors, climate, fuel type and other variables. The recommended heated area for a given appliance is defined by the manufacturer as its capacity to maintain a minimum acceptable temperature in the designated area in case of a power failure.

⁽²⁾ The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft³ and 20 lb/ft³ and reloading intervals ranging from 60 to 120 minutes. Other performances are based on a fuel load prescribed by the standard without any reloading between start and finish. The specified loading density varies between 7 lb/ft³ and 12 lb/ft³. The moisture content is between 19% and 25%.

⁽³⁾ As measured per CSA B415.1-10 stack loss method.

⁽⁴⁾ Higher Heating Value of the fuel.

⁽⁵⁾ Lower Heating Value of the fuel.

⁽⁶⁾ Performances based on a fuel load prescribed by the standard at 7 lb/ft³ and with a moisture content between 19% and 25%.

⁽⁷⁾ Optimum overall efficiency at a specific burn rate (LHV).

⁽⁸⁾ The optimum heat transfer efficiency is for the low burn rate (using HHV) and represents the appliance’s ability to convert the energy contained in the wood logs into energy transferred to the room in the form of heat and does not take into account the chemical losses during combustion.

⁽⁹⁾ This appliance is officially tested and certified by an independent agency.

⁽¹⁰⁾ Carbon monoxyde.

General features