Inspire 2000 Wood Stove by Osburn

Proudly Made in Quebec ⚜️

Looking to step off the beaten path? The Osburn Inspire introduces a timeless style built to outlast changing trends, with pure lines and balanced proportions that allow it to stand proudly alongside the finest European-style wood stoves. Its contemporary design is available with a steel base, soapstone base, or a minimalist base for those who prefer to place the unit directly on a non-combustible podium.

Equipped with a 2.3 cu. ft. firebox and an outside air intake, the Inspire meets strict domestic energy standards, and can even be installed in mobile homes.

Certified by the EPA with emissions as low as 2.3 g/h, the Inspire also complies with the most rigorous North American environmental requirements. A true symbol of quality, reliability, and durability, it showcases Osburn’s unwavering commitment to sustainability—much to the delight of wood heating enthusiasts.

New Option – NightFlame Ceramic Glass
The ROBAX® NightFlame ceramic glass panels combine innovation and elegance. This advanced glass changes its appearance once the fire goes out, discreetly concealing the interior of the stove when not in use, while providing a crystal-clear view of the flames when burning.

👉 Discover the many qualities of the Osburn Inspire wood stove.

Appliance performance ⁽¹⁾

⁽¹⁾ Values are as measured per test method, except for the recommended heating area, firebox volume, maximum burn time and maximum heat output.

⁽⁾ Recommended heating area and maximum burn time may vary subject to location in home, chimney draft,heat loss factors, climate, fuel type and other variables. The recommended heated area for a given appliance is defined by the manufacturer as its capacity to maintain a minimum acceptable temperature in the designated area in case of a power failure.

⁽²⁾ The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft³ and 20 lb/ft³ and reloading intervals ranging from 60 to 120 minutes. Other performances are based on a fuel load prescribed by the standard without any reloading between start and finish. The specified loading density varies between 7 lb/ft³ and 12 lb/ft³. The moisture content is between 19% and 25%.

⁽³⁾ As measured per CSA B415.1-10 stack loss method.

⁽⁴⁾ Higher Heating Value of the fuel.

⁽⁵⁾ Lower Heating Value of the fuel.

⁽⁶⁾ Performances based on a fuel load prescribed by the standard at 7 lb/ft³ and with a moisture content between 19% and 25%.

⁽⁷⁾ Optimum overall efficiency at a specific burn rate (LHV).

⁽⁸⁾ The optimum heat transfer efficiency is for the low burn rate (using HHV) and represents the appliance’s ability to convert the energy contained in the wood logs into energy transferred to the room in the form of heat and does not take into account the chemical losses during combustion.

⁽⁹⁾ This appliance is officially tested and certified by an independent agency.

⁽¹⁰⁾ Carbon monoxyde.

General features